The sensor can be mounted almost anywhere thanks to ø8 mm ø0.31" slim body that can be mounted anywhere along its body. If you use one of the dedicated brackets, you do not need to fabricate a slotted jig. The flange type can also be directly mounted by simply drilling a ø10 mm ø0.39" hole.
Measurements can be performed with the sensor head secured in place, so no mechanism is required to move the sensor head itself. This allows for space-saving installation which can greatly reduce costs at initial setup. Plus any worries about variations in accuracy due to the jig are eliminated.
A variety of detection modes are standard.
Calculations between additional amplifier units can be easily
configured simply by selecting the desired mode.
Positioning the target between two sensor heads will display the outer diameter.
By subtracting the minimum value from the maximum value the flatness will be displayed.
SINGLE HEAD
MULTIPLE HEADS/when additional amplifi er units are installed (application modes)